Dainty Petal Necklace

Dainty petal felt flower necklace The Handmade Florist

This gorgeously dainty necklace is a quick make to whip up in any colour to suit any outfit. In fact, the flower could be turned into a brooch, hair clip, planner clip... so many possibilities, but I do love it as a necklace!

Dainty Petal Necklace

TOOLS AND MATERIALS:

dainty petal necklace

  • Small scraps of felt in various colours
  • Felt ball (1cm) - or you could use a button, bead or rolled up skinny strip of felt - for the flower centre
  • Necklace chain
  • Scissors
  • Glue gun

TO MAKE YOUR NECKLACE:

Cut two equal circles of felt for the base of the flower. This will determine the overall size of your necklace so the size is up to you, but my circles were 4cm across.

Now cut small petals from each of your chosen felt colours. You'll need 16 petals in total. The petals should measure approximately half the width of your base circle, from point to point i.e. each of my petals was 2cm long.

 dainty petal necklace

Glue the two base circles together. This helps to give a sturdy base to your flower and something to attach your necklace chain to.

dainty petal necklace

Begin gluing your petals to the base circle. I began with two petals of the same colour opposite each other and two more in a different colour in the gaps between these. The petals should reach out slightly wider than the edge of the circle and there should be a gap at the centre.

dainty petal necklace

Repeat with another layer of four petals, in the gaps between the petals from the first layer.

dainty petal necklace

Continue with another four petals, positioning them slightly to the side of the gaps below so the bottom layer of petals still shows through.

dainty petal necklace

Finish with a final layer of four petals, slightly to the side of the previous four.

dainty petal necklace

Place a blob of glue in the centre of the petals and fix the felt ball (or your other chosen flower centre) in place here.

dainty petal necklace

Cut a small tab of felt for the back of the necklace (mine measured approximately 3cm x 1.5cm). Glue along the top edge.

dainty petal necklace

Fix the top edge of the tab to the top of the base circle, then slide the necklace chain underneath and seal the tab below (being careful not to glue the chain itself!).

dainty petal necklace

dainty petal necklace

dainty petal necklace